ResMed AirCurve 11 VAuto error codes and alerts

High leak (tub or side cover) High leak detected. Check your humidifier or side cover.

What it means: The tub or side cover is not seated properly.

What to do: Reinsert the tub or side cover until it is correctly in place.

High leak (tubing) High leak detected. Connect your tubing.

What it means: The tubing is loose, or the mask is not fitted correctly.

What to do: Connect the tubing firmly at both ends and refit the mask or run Mask Fit.

Tubing blocked Tubing blocked. Check your tubing.

What it means: Airflow through the tubing is blocked.

What to do: Clear the blockage and press the Start Therapy/Standby button to restart.

SD card read only Read only card, remove, unlock and re-insert SD card

What it means: The card's lock switch is set to read-only.

What to do: Slide the switch to unlock and reinsert the card.

Error 4 System fault, refer to user guide, Error 4

What it means: Possible causes: the machine was left somewhere hot, the air filter is blocked, or there is water in the tubing.

What to do: Let it cool, replace a blocked filter or empty the tubing, then disconnect and reconnect the AC adaptor.

Error X (other numbers) System fault, refer to user guide, Error X

What it means: An error has occurred on the device.

What to do: Remove power and restart. If the error persists, contact your care professional. Do not open the device.

Humidifier fault icon Humidifier fault icon on the status bar

What it means: A humidifier fault was detected; therapy runs without heating.

What to do: Reseat the tub and restart. If the icon remains, contact your care provider.

Device cooling icon Device cooling icon on the status bar

What it means: The side cover is connected and the device is cooling.

What to do: No action needed; let it finish.